How to Clean Your RaveBeetle Hydration Bladder: A Step-by-Step Guide

Hydration Bladder Cleaning Guide

To keep your hydration bladder fresh and ready for your next festival, follow this simple guide using the Ravebeetle Bladder Cleaning Kit and a bottle cleaning tablet.

You Will Need:

• Ravebeetle Bladder Cleaning Kit
• A bottle cleaning tablet

Step-by-Step Instructions:

1. Rinse the Reservoir:

   • Begin by rinsing the reservoir with clean water. Repeat a few times to remove any loose dirt or residue.

2. Drain the Reservoir:

   • Squeeze the bite valve to drain the water. This also helps flush out any residue in the insulated hose.

3. Scrub the Reservoir:

   • Use the reservoir brush from your cleaning kit to scrub the inside of the reservoir thoroughly.

4. Detach the Hose:

   • Remove the hose from the reservoir. Using the hose brush, scrub the inside of the hose for a deep clean.

5. Remove and Clean the Bite Valve:

   • Detach the bite valve from the hose. Use the small brush to clean both the valve and the end of the hose.

6. Add the Cleaning Tablet:

   • Place a bottle cleaning tablet inside the reservoir. Fill it with water, seal the bladder, and shake well.

7. Let It Sit:

   • Allow the cleaning solution to sit in the bladder for 30 minutes to disinfect and remove any buildup.

8. Rinse Thoroughly:

   • After 30 minutes, drain the solution by squeezing the bite valve. Rinse the reservoir several times with clean water to ensure all the cleaning solution is removed.

9. Rinse the Hose:

   • Run clean water through the hose to flush out any remaining solution.

10. Dry the Reservoir:

• Use the hanger from the cleaning kit to hang the bladder upside down, allowing it to air dry completely.

11. Ready for Your Next Festival:

• Once fully dry, your hydration bladder is clean and ready to be used at your next festival!

Cleaning your bladder regularly keeps your water tasting fresh and your gear ready for any adventure!